Bottle sleeve label machine Sleeve label packaging machine
When the sensor detects the bottle, the label feeding motor begins to feed the label. When the label feeding motor receives the signal that the label feeding is complete, it stops the label feeding. Mark cutting motor starts mark cutting. The bottle does not stop during the feeding and cutting process of the label. When the push-off photoelectric sensor detects a bottle and determines that continuous production is required, the push-off screw begins to push the bottle (the role of the push-off screw is to evenly distribute the bottle at uneven spacing and initial speed), and the bottle enters the core unit of the labeling system. When the labeling photoelectric sensor detects a bottle, it immediately sends the information to the control center PLC, which successively issues four instructions: label feeding, positioning, label cutting, and label shooting. When the label shooting is complete, the labeling process of a bottle is complete, and then the label reduction unit is entered.
When the sensor sends a signal that the label is ready to be labeled, the driving wheel of the labeling machine rotates. Since the drum label is in a tensioned state on the device, when the bottom paper is running close to the stripping plate and changes the direction, the front end of the label is forced out and ready for labeling due to the rigidity of its own material. At this time, the labeling object is located at the bottom of the label, and synchronous labeling is realized under the action of the labeling wheel. After labeling, the sensor under the drum label sends a signal to stop running, the driving wheel is stationary, and a labeling cycle is completed.
Submitted successfully
We will contact you as soon as possible